CurtainFall/RainCurtain Quote Request
Call 800-420-3255 email: cs@oreqcorp.com www.oreqcorp.com
Date:
Swimming Pool Dist. Name: Branch Location City: Mark Here If Distributor Not Used
Company Name or Acct. #:
Ship To Address or Acct. #: Job Ref. Name (if applicable):
Address: City:
Contact: Phone: Email: * Person to Receive Quote
1. Select Material:
Plastic
White Tan Black
Gray Clear  
Stainless Steel
(Patina not available on S.S.)
Brushed Finish
Polished Finish		 Brass
(Material naturally patinas.)
Brushed Finish
Patina Finish*		 Copper
(Material naturally patinas.)
Brushed Finish
Patina Finish*
The metal finish provided is applied to 3" of the top and bottom front lip surface.
*Patina options
Antique
Verde
Antique Verde
WARRANTY DISCLAIMER: Salt chlorine systems can cause surface rust and corrosive conditions for stainless steel. Stainless steel used in conjunction with salt systems voids the warranty.
2. Select Style:
CurtainFall 90°
 RainCurtain 90°
 CurtainFall
 RainCurtain*
 2A *Check desired hole pattern.
 1" Spacing (1 per in.)  Good
 1/2" Spacing Offset  Better
 1/2" Spacing (2 per in.)  Best
  * Not shown to scale.
3. Dimensions: (Note as needed.)
Standard Body: Plastic: 2¾"w x 35⁄8"h
Metal: 3"w x 4"h
Standard Lip Lengths: 3" lip, 6" lip, or 12" lip

How much of the unit will be exposed?
3.1 Standard Feature
Length of A:
Use Standard Lip Length if applicable. See above left.

Length of L (Lip):
Min. 3" lip requirement
3.2 Convex Lip


Lip Length L: Min. 3" lip requirement.		 Required Measurements:

Length of A-B:

Length of C-C:

Radius R:
If radius is known, please provide.
3.3 Concave Lip


Lip Length L: Min. 3" lip requirement.		 Required Measurements:

Length of A-B:

Length of C-C:

Radius R:
If radius is known, please provide.
3.4 Convex Curved Vessel


Lip Length L: Min. 3" lip requirement.		 Required Measurements:

Length of A-A:

Length of A-B:

Length of C-C:

Length of A-D:

Radius R:
If radius is known, please provide.
3.5 Concave Curved Vessel


Lip Length L: Min. 3" lip requirement.		 Required Measurements:

Length of A-A:

Length of A-B:

Length of C-C:

Length of A-D:

Radius R:
If radius is known, please provide.
4. Select Inlet Location:
(Some units may require multiple inlets)

5. Quantity: 		 
6. Upload Image File(s): (Must be a .jpg)
(Must be a .jpg)
7. Special Instructions:
© Copyright 2019, Oreq Corporation. All Rights Reserved - RV 12/2019